WangYe WY50QT-86 Manuel d'utilisateur télécharger pdf (Page 16)

- 26 -

Change the engine oil and filter net clean（Diagram 24）

Change the engine oil

l Change the engine oil only when the engine is not cool and the vehicle is

supporting by jiffy Stand, to pour out all the oil completely and quickly.

Filter net clean

l Screw out the the cover of oil hole /oil dip rod and the cover of oil filter

screen,then unbolt the oil filter(1) Net(2) and the spring (3) lean the oil

filter net with the impregnant

• Clean the oil filter net with the impregnant

• Fill in the oil filter net,spring and the cover of oil filter screen

• Cover of oil hole / oil dip rod. When measuring the oil level,

do not screw down the cover of oil hole / oil dip rod.

• Screw up the cover of oil hole / oil dip rod.

• Let the engine work at the idle speed for several minutes and stop it .then start the engine.。

• Remeasure the oil mass. Make sure the oil mass is near to or in the mark of upper limit

without leakage.

Diagram 26

- 27 -

Change the gear box oil（Diagram 27）

Recommend to use the oil NO.

SAE 80W/90（North cold district can use the special oil）

Refuel volume

Volume when change：0.10L

• Fix the motorcycle with the main stand

Remove the injection oil bolt 1 and leak oil bolt 2

.Attention ： When leakage,the engine should take a

certain temperature. For keeping the gear box is empty.

With the main stand to fix the vehicle.

• Fix it after cleaning the leak oil bolt and screw up.

• Full in the gear box with engine oil by injector

• Fix the injection oil bolt and screw up.

•

Diagram 27

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

WangYe WY50QT-86 Manuel d'utilisateur Page 16