WangYe WY50QT-86 Manuel d'utilisateur télécharger pdf (Page 10)

- 14 -

Starting engine(diagram 19)

• Preparation：release the vehicle main stand,pull the key in to

ignition switch and trun to “ ”.

• Electric-start: press start button (1) while applying the

throttle slowly, and the engine starts in less than 5 seconds.

Attention：

• Before starting the engine,hold the brake handle tightly.

• When eleectric-start fails,try it again after 30 seconds.If

it also doesn’t work,please try kick-start.

• Engine kick-start : Turn ignition switch on and apply the throttle slowly, step

kick-starter pedal down quickly with strength.

Attention：After starting the engine, do pull the pedal back to original position.

To use the vehicle after a long time, it is better to kick the pedal several times at first with

ignition switch off, so the engine can start easier.

• If cold start the engine, warm up engine for about 3 minutes before driving.

Diagram

- 15 -

Driving the motorcycle

Warning

• When riding the motor, the temperature of the exhaust pipe and muffler is very high, so

you’d better wear long pants to avoid touching with the hot parts of the exhaustion

system

• It is necessary to wear helmet, goggles and gloves while riding the vehicle

• When driving,do not wear loosen or unsuitable clothes. Otherwise the clothes may hook

with the handle bar, start pedal or the stand.

• Each equipment of the motorcycle should accord with the traffic law of local

government

• Attention：Control the speed and payload during the first1000kmPayload among100kg

is appropriate (including driver)Overtaking and overloading will shorten the life of

engine, so change the crankcase oil after 300km.

Speed reference 2：

Blank 2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Pas de commentaire

WangYe WY50QT-86 Manuel d'utilisateur Page 10